If an inexperienced contractor didn t install the materials well leaks could occur.
Roof leaking on outer eadge.
This should cover the most leak prone areas.
Ice dams block the natural flow of water down a roof.
Depending on how the roofs join you may have to cut a slot to work it in far enough.
Dig out any cracked or dry caulking that isn t properly sealing adjoining surfaces and replace with silicone caulk.
Rotten or missing trim or siding can allow water to leak behind flashing and into your roof.
Depending on how the roofs join you may have to cut a slot to work it in far enough.
At a bare minimum there also should be tar paper under the starter and shingles.
Ice dams are generally fixed by a crew that uses steam to melt away the ice buildup allowing melting snow to drain off the roof rather than back up under shingles.
This should cover the most leak prone areas.
Dormer leaks can be caused from a number of issues.
A roof leak at the edge of a dormer can allow a lot of water to enter your home.
This leads to a good deal of frustration for the homeowner who is attempting to repair it.
The source of the roof leak on the outside of the home rarely matches where the leak appears on the inside of the home.
If the leaking appears to be caused by ice buildup on the edges of the roof this likely will need to be handled by a professional ice removal crew.
Worn out flashing or missing sealant can also cause roof leaks around dormers.
Then reshingle sliding metal step flashing behind the fascia board the trim behind the gutter.
These leaks can happen even if everything on your roof is just fine.
It bends around the edge of the roof channeling any moisture that penetrates the shingles away from the roof decking.
The water begins to back up under flashings shingles tar paper etc.
It should overlap another piece of ice and water barrier laid below all the way down to the roof edge.
There should be a starter strip which is most often simply shingles installed up side down that where installed so the seams do not line up with the seams in the shingles.
Lift up the shingle on the bottom edge to see what s under it.
Recaulk the corner flashing if any areas have hardened caulk.
Then reshingle sliding metal step flashing behind the fascia board the trim behind the gutter.
Ice dam leaks plague people in the snow belt.
Roof flashing roof vents or roof membranes can leak from poor installation.
Sometimes determining the source of the roof leak can be an even greater challenge.
Replace any missing or rotted siding above the step flashing on dormers.
